Toroidal Flexible Current Transformer Wound Core
Oct 09, 2025
Leave a message
Product Definition
A wound core is formed by continuously winding a thin strip of magnetic material into a circular or toroidal shape. The continuous winding creates a seamless magnetic path with no air gaps, which concentrates the magnetic flux inside the core and minimizes leakage. Toroidal wound cores are the basis of flexible current transformers and window-type current transformers, where the primary conductor passes through the window and the secondary winding is wound directly on the core.
This article compares the main wound core materials and explains how to select the right one for current transformer applications.
Wound Core Materials
| Material | Typical permeability | Saturation (T) | Best suited to |
|---|---|---|---|
| Silicon steel | Moderate | 1.8-2.0 | Power-frequency CTs and transformers |
| Ferrite | Low-moderate | 0.4-0.5 | High-frequency and RF applications |
| Nickel-iron (permalloy) | Very high | 0.7-0.8 | Precision and instrument CTs |
| Amorphous alloy | High | 1.5-1.6 | Low-loss, high-accuracy CTs |
| Nanocrystalline | Highest | 1.2-1.25 | High-accuracy metering CTs and EMC chokes |
Material Characteristics
Silicon steel wound cores offer a high saturation flux density (1.8-2.0 T) and good magnetic conductivity at power frequency. They handle large magnetic fluxes and are commonly used in power transformers, current transformers and power supply inductors, where their main advantage is low cost at high saturation.
Ferrite has a very high electrical resistivity, which reduces eddy current losses at high frequency. Ferrite wound cores are used in RF circuits, high-frequency switching power supply transformers and communication inductors, but their low saturation flux density limits the power density.
Nickel-iron alloys, such as 80% Ni permalloy, provide extremely high permeability and very low coercivity, making them ideal for precision current transformers, magnetic sensors and high-end audio transformers where sensitivity and accuracy matter more than saturation.
Amorphous and nanocrystalline alloys combine low core loss with high permeability. Nanocrystalline material in particular reaches an initial permeability of 80,000-120,000 with saturation around 1.2 T, which makes it the preferred choice for high-accuracy metering current transformers.
Selection Guidelines for Current Transformers
Define the accuracy class (for example 0.2, 0.5 or 1) and the burden per IEC 61869-2 before choosing the material.
For metering applications where phase error matters, choose high-permeability materials such as nanocrystalline or permalloy.
For protection CTs that must withstand high fault currents without saturating, check the saturation flux density and the knee point.
Consider the operating frequency: above 1 kHz, silicon steel is usually replaced by ferrite, amorphous or nanocrystalline material.
For flexible CTs that clamp around cables, specify the window size and the required output at the rated primary current.
FAQ
Q: What is the advantage of a toroidal wound core?
A: The seamless magnetic path eliminates air-gap losses and minimizes flux leakage, giving high accuracy and a low magnetizing current.
Q: Which material gives the highest accuracy?
A: Nanocrystalline and nickel-iron (permalloy) cores give the lowest ratio and phase errors because of their very high permeability.
Q: Can ferrite be used for power-frequency current transformers?
A: Yes, but its low saturation flux density limits the linear range; silicon steel or nanocrystalline material is usually better at 50/60 Hz.
Q: What does flexible mean in a flexible CT?
A: The core is split or hinged so it can be opened and clamped around an existing cable without disconnecting the circuit.
Q: How is accuracy tested?
A: Per IEC 61869-2, using a standard CT and the specified burden at defined percentages of the rated current.

