Cold rolled silicon steel sheet stress relief annealing process
Nov 17, 2023
Leave a message
GNEE New Material silicon steel
1. Put the silicon steel sheets to be annealed into iron boxes (according to the size of the silicon steel sheets, be careful not to pack more than three layers), install them on the rack, and cover each box of silicon steel sheets with a cover plate slightly smaller than the iron box (silicon steel sheet materials are recommended) Do), hoist it into the furnace and lock the furnace cover.
2. Install the three Dahua thermocouples on the furnace body, install the chimney, and open the exhaust valve.
3. Check whether the voltage, current, and instruments of the electrical cabinet are normal, install the recording paper of Dahua Meter, and check the normal paper feeding of the recording paper (first turn on the power switch).
4. Set the initial temperature of the temperature control meter to 400°C, check whether the currents of the power meter are consistent, and after ensuring that the adjustments are consistent, turn on the heating switch for heating.
5. Check whether the instruments in the electric room are normal or not, and adjust the power of the stove.
6. Connect the nitrogen, check for air leakage, and check the normal supply of circulating water.
7. When the temperature rises to 400°C, open the nitrogen valve and inject 100-200ml of nitrogen. At this time, open the circulating water valve.
8. When the temperature is determined to rise to 400°C, perform constant temperature control for about 1 hour, and confirm that the temperature of the Dahua watch is also around 400°C (there is not much exhaust gas at this time).
9. After the heat preservation is completed, set the temperature control meter to 500°C and proceed with heating. During this period, pay attention to whether the condition of the ammeter is consistent, and deal with any problems in a timely manner.
10. When the temperature rises to 500°C, maintain the temperature for about 45 minutes. At this time, check whether there is any change in the furnace body, whether there is air leakage, and whether the circulating water supply is normal.
11. After the constant temperature is completed, set the temperature control meter to 600°C and start heating. Increase the nitrogen pressure regulating valve and inject 200-400 ml of nitrogen. At this time, there will be more waste gas.
12. When the temperature rises to 600℃, keep the temperature constant for about 45 minutes. At this time, check whether the voltage is normal.
13. Finally, set the temperature control table to 680℃-750℃ (depending on the material of the silicon steel sheet. The general annealing temperature of cold-rolled non-oriented silicon steel sheets with low grades domestically produced B50A600, 50W600, 50AW600, and 50WW540 is around 680℃, and imported The same material can be appropriately +20°C. The general annealing temperature for non-oriented high-grade grades is around 750°C. The general annealing temperature for cold-rolled oriented silicon steel sheets is around 820°C). The nitrogen can be turned on higher, or 400 ml of nitrogen can be maintained. At this time, there will be more waste gas.
14. After the temperature rises to the set temperature, the constant temperature time should not be less than 2 hours, and the Dahua watch should also be around the set temperature. At this time, the exhaust valve can be turned down.
15. After finishing, turn down the exhaust valve (just leave it open), inject nitrogen at 100-200ml, close the circulating water valve (the water outlet valve is always open), and turn off the heating switch and power switch.
16. After the inspection is correct, the silicon steel sheets in the furnace will enter a natural cooling state during the stress relief annealing process. They can be released from the furnace only when the temperature in the furnace drops below 380°C (350°C).



