CGO Cold Rolled Grain Oriented Electrical Steel: Properties and Applications

Oct 09, 2025

Leave a message

What Is CGO Electrical Steel?

CGO, or cold-rolled grain-oriented electrical steel, is a soft magnetic material whose crystal grains are aligned in the rolling direction. This oriented structure gives the steel high permeability and low core loss when the magnetic flux follows the rolling direction, which is why CGO is the standard material for transformer cores. It is produced in thicknesses such as 0.23 mm, 0.27 mm, 0.30 mm and 0.35 mm and is specified in standards such as GB/T 2521 and IEC 60404-8-7.

Manufacturing Process

CGO production begins with hot-rolled coils that are cold-rolled to final gauge, followed by decarburization annealing, application of a magnesium-oxide coating and high-temperature secondary recrystallization annealing, which forms the Goss texture. A final insulating coating is applied before slitting. High-permeability grades may receive laser or mechanical scribing to refine the magnetic domain structure and further reduce core loss. Laser scribing is a refinement applied to finished grain-oriented steel; it is not the defining process of CGO production.

Key Magnetic Properties

Low core loss: total losses at 1.7 T, 50 Hz typically range from about 0.8 W/kg to 1.5 W/kg depending on grade.

High permeability: magnetization at 800 A/m typically exceeds 1.7 T for high-grade material.

Low magnetostriction: contributes to reduced transformer noise and vibration.

High resistivity: lowers eddy current loss, especially at higher frequencies.

Typical Grades

Thickness (mm) Grade example Max core loss at 1.7 T, 50 Hz (W/kg)
0.23 23QG085 0.85
0.27 27QG095 0.95
0.30 30QG120 1.20
0.35 35QG135 1.35

Applications

CGO steel is used mainly in power and distribution transformer cores, where it reduces no-load losses and enables compact designs. It also appears in generator stators, large motor cores, reactors and instrument transformers.

Selection Considerations

When choosing CGO steel, compare guaranteed core loss at the operating flux density, lamination factor, insulation coating quality and surface flatness. Grade selection should balance material cost against the capitalized value of no-load loss over the transformer life.

FAQ

What is the difference between CGO and HGO?

HGO refers to high-permeability grain-oriented steel produced with inhibitors that give a sharper Goss texture and lower core loss. CGO covers conventional grain-oriented grades; both are oriented steels, but HGO offers better magnetic performance at higher cost.

Why is grain orientation important?

Oriented grains make the steel highly permeable along the rolling direction, so the core can operate at higher flux density with lower magnetizing current and lower loss.

Can CGO steel be used for motors?

For rotating machines with rotating flux, non-oriented steel is usually preferred. CGO is used in transformer cores and some large generator applications where flux is predominantly unidirectional.

What standards govern CGO steel?

Common specification documents are GB/T 2521 for grain-oriented electrical steel, IEC 60404-8-7 for magnetic material specifications and ASTM A876 for oriented silicon steel.

How does laser scribing reduce loss?

Scribing creates fine lines on the surface that refine magnetic domains, reducing anomalous eddy current loss. The effect is a core loss reduction typically of several percent on high-grade material.

Send Inquiry