Difference Between Cold Rolled Steel And Hot Rolled Steel

Feb 01, 2024

Leave a message

GNEE New Material Cold Rolled Carbon Steel Coil

Cold-rolled steel:

Cold-rolled sheet is a product made by rolling hot-rolled coil as raw material at room temperature lower than the recrystallization temperature. It is mostly used in automobile manufacturing, electrical products, etc.

 

Hot-rolled steel:

By definition, ingots or billets are difficult to deform at room temperature and are difficult to machine. Generally, it is heated to 1100-1250 °C for rolling, and this rolling process is called hot rolling.

Cold Rolled Steel Coil

Cold Rolled Coil

Cold-rolled steel plate product category:

Low-carbon and ultra-low-carbon steels

Continuous cold-rolled carbon structural steel plate and steel strip

Continuous cold-rolled high-strength baking hardened steel plate and steel strip

Continuous cold-rolled high-strength duplex steel plate and steel strip

Continuous cold-rolled high-strength low-alloy steel plate and steel strip

 

Apply:

Cold rolled strip has a wide range of applications, such as automobile manufacturing, electrical products, rolling stock, aviation, precision instruments, canned food, etc. Cold-rolled thin steel plate is the abbreviation of ordinary carbon structural steel cold-rolled plate. Cold-rolled steel plate is hot-rolled steel strip with ordinary carbon structural steel, which is further cold-rolled into a steel plate with a thickness of less than 4mm. Due to rolling at room temperature, no oxide scale is produced. As a result, the cold plate has good surface quality and high dimensional accuracy. Coupled with annealing treatment, its mechanical properties and process properties are better than those of hot-rolled steel plate. In many areas, it has been gradually used to replace hot-rolled steel plates.

Cold Rolled Stainless Steel Coil Application

CR Steel Coil

Difference Between Hot Rolled and Cold Rolled:

1. Appearance and surface quality: Since the cold plate is obtained after the cold rolling process of the hot plate, and some surface finishing is carried out at the same time, the cold plate is better than the hot plate in terms of surface quality (such as surface roughness). It is good, so if there are higher requirements for the quality of the plating of the product, such as the subsequent coating, the cold plate is generally selected, and the hot plate is divided into pickling plate and non-pickling board. Normal metallic color, but not cold rolled, so the surface is not as high as a cold plate. Pickle-free plates usually have a layer of oxide on the surface, which is black, or have a black layer of ferric tetroxide. , and if the storage environment is not good, generally bring some embroidery.

2. Performance: Under normal circumstances, the mechanical properties of the hot plate and the cold plate are considered indistinguishable in the project, although the cold plate has a certain degree of work hardening in the cold rolling process, (but the irregular has strict requirements for mechanical properties, then it needs to be treated differently), the yield strength of the cold plate is usually slightly higher than that of the hot plate, and the surface hardness is also higher, depending on the degree of processing, the cold plate annealing. But no matter how annealed, the strength of the cold plate is higher than that of the hot plate.

3. Molding performance, because the performance of hot and cold plates is basically not much different, so the influencing factors of molding performance depend on the different surface quality. Due to the better surface quality of the cold plate, in general, the same material is used. Steel plates and cold plates have a better forming appearance than hot plates.

Send Inquiry