Color-Coated Sheet Processing
Feb 28, 2024
Leave a message
Processing is an important link that affects the quality of color-coated sheet. In order to ensure product quality, some precautions during processing are given below for reference. For specific regulations on processing, please refer to relevant materials or consult experts.
Because of the coating on the surface of the color-coated sheet, there are many differences between the ordinary cold-rolled sheet and the coated sheet during processing. The main difference is that the forming process must be performed under the premise of ensuring the integrity of the coating. The precautions during processing are as follows:
1. Mechanical properties are an important index to measure formability and an important parameter for determining and adjusting the processing technology, so it should be considered first during processing.
2. Indexes such as pencil hardness, T-bend and impact work are closely related to processing performance, so they should be fully considered.
3. When the shape of the part is complex and the degree of deformation is large, multi-pass forming should be used. If it is formed at one time, the bond between the coating and the substrate may be damaged due to excessive deformation.
4. The appropriate gap should be set according to the mold shape, deformation characteristics, process conditions and other factors during processing, and the thickness of the coating should be considered when setting the gap.
5. Most coatings can be used as solid lubricants and can meet the lubrication requirements of most forming processes. Some coatings can improve the lubricity of the coating by adjusting the formulation. If the lubricity of the coating is insufficient, the lubricity can be improved by oiling, waxing, and peeling protective film. But it should be noted that wet lubricant is easy to absorb dirt and should be removed before installation. The peelable protective film should also be removed as soon as possible after construction.
6. A reasonable processing speed should be set according to factors such as equipment conditions, process conditions, and part shapes. Too high a deformation speed will easily cause the coating to peel off. When the temperature is low, the flexibility of the coating decreases, so low-temperature processing should be avoided. If the ambient temperature is low, the material should be heated to a certain temperature before processing.
7. The cut section produced during processing is prone to corrosion, so necessary protective measures should be taken, such as protective coatings, embedded seals, etc.
8. Minimize the burrs on the cut surface during processing to prevent the burrs from scratching the surface.
9. All surfaces in contact with the coating should be kept clean and tidy, and the chips and metal particles generated during processing should be cleaned up in time to prevent foreign matter from damaging the coating surface.
10. During processing, the wear of the forming roller surface or the mold surface should be minimized, and the contact surface should be kept smooth and clean to prevent defects such as indentation and scratches on the coating surface.
11. The construction method of pre-assembled in the factory and then sent to the site for installation should be adopted as much as possible, and protective measures should be taken during installation to prevent damage to the coating.
12. If the coating surface is found to be damaged during processing, special repair paint should be used to repair it in time to prevent corrosion of the damaged area.


