Three-Phase 10kv 100kVA Oil Immersed Power Transformer
Oct 29, 2025
Leave a message
10kv 100kVA Oil Immersed Transformer Main Characteristics:
2. Core is made of high quality cold-rolled grain-oriented silicon steel sheet which produced in step-lap technology.
3. Winding is using high strength enameled wire or paper-insulated wire or copper belt, which offers uniform distribution of ampere-turns, reasonable insulation structure with high ability to withstand short-circuit.
4. Oil tank is corrugated type with high corrosion resistance. Tank surface pre-treatment liquid and coating powder adopts international top brands. The tank is degreasing, pickling, phosphorated, electrophoresis by automatic production lines, then power spray coating and heat-solidify.
5. The active part applies core free-hanging structure. The gasket is made of high-quality acrylate rubber which can inhibit ageing caused by sun and heat.
10kv 100kVA Oil Immersed Transformer Applications
2. Utility: Generation, transmission, distribution substations, water and waste water treatment plants.
3. Oil and Gas: Oil and gas plants, petrochemical plants and refineries.
Oil-filled Transformer S13-M-(30-2500)/10-0.4KV Parameter Standards |
||||||
| Transformer Model | Rated Capacity (kVA) | No-load Loss (W) | Load Loss (W) | No-load current (%) | Impedance (%) | |
| Dyn11 | Yyn0 | |||||
| S13-30/10 | 30 | 80 | 630 | 600 | 0.9 | 4 |
| S13-50/10 | 50 | 100 | 910 | 870 | 0.8 | |
| S13-50/10 | 63 | 110 | 1090 | 1040 | 0.7 | |
| S13-50/10 | 80 | 130 | 1310 | 1250 | 0.7 | |
| S13-100/10 | 100 | 150 | 1580 | 1500 | 0.65 | |
| S13-125/10 | 125 | 170 | 1890 | 1800 | 0.65 | |
| S13-160/10 | 160 | 200 | 2310 | 2200 | 0.6 | |
| S13-200/10 | 200 | 240 | 2730 | 2600 | 0.6 | |
| S13-250/10 | 250 | 290 | 3200 | 3050 | 0.55 | |
| S13-315/10 | 315 | 340 | 3830 | 3650 | 0.55 | |
| S13-400/10 | 400 | 410 | 4520 | 4300 | 0.5 | |
| S13-1500/10 | 500 | 480 | 5410 | 5150 | 0.5 | |
| S13-6300/10 | 630 | 570 | 6200 | 0.35 | 4.5 | |
| S13-800/10 | 800 | 700 | 7500 | 0.35 | ||
| S13-1000/10 | 1000 | 830 | 10300 | 0.35 | ||
| S13-1250/10 | 1250 | 970 | 12000 | 0.3 | ||
| S13-1600/10 | 1600 | 1170 | 14500 | 0.3 | ||
| S13-2000/10 | 2000 | 1550 | 18300 | 0.25 | 5 | |
| S13-2500/10 | 2500 | 1830 | 21200 | 0.25 | ||
| Note: 1. For transformers with no-load excitation adjustment, high voltage can provide ±5% or ±2×2.5% voltage regulation range. | ||||||
| Core | Core-type Transformer |
| Usage | Power Transformer |
| Winding Type | Multi-winding Transformer |
| Shape of Core | Ring |
| Transport Package | Wooden Case |
| Frequency Characteristics | High Frequency |
company profile
GNEE TRANSFORMER has strong production capacity and an efficient marketing team.
Our transformer products include 500kV, 400kV, 330kV, 220kV, and 110kV ultra-high voltage transformers, various dry-type transformers/oil immersed transformers/amorphous alloy transformers of 35kV and below, new energy transformers, and prefabricated substations,
Export series: single-phase transformer, three-phase transformer, cylindrical transformer, isolation transformer, control transformer, voltage regulator and other products, And various specifications of special transformers such as grounding transformers, arc suppression coils, Bitcoin transformers, prefabricated cabins, reactors, electric furnace transformers, rectifier transformers, mining transformers, marine transformers, etc.
GNEE TRANSFORMER has successively passed ISO9001, ISO14001, ISO45001, SA8000 system certification. At the same time, 10kV and 35KV level distribution transformers and box type substations have obtained interna- tional Electrotechnical Commission IEC certification, US UL certification, German TUV certification, EU CE certification, Dutch KEMA certification, and GOST certification. Our product sales cover the global market, including 72 countries and regions such as the United States, Europe, Canada, Mexico, etc.
transformer Workshop equipment display
types of transformer from GNEE
Get Transformer Order specification
GNEE Transformer Order specification
|
When choosing our company's products, please provide the following data to better serve you. |
||
|
Demander |
||
|
Demander: |
Telephonemethods: |
Fax: |
|
Project technical leader: |
Telephonemethods: |
Mailbox: |
|
Transformer type selection |
||
|
□Dry transformer {□SC(B) Epoxy resin □SC(B) Non-encapsulated} □American Box(ZGS) {□Terminal type(-Z-) □Ring network type(-H-)} □European Box change(YBM){□ Dry change □Oil change} |
□ Oil-immersed transformer{□ Fully sealed(-M-) □Oil-bearing pillow} □Amorphous alloy transformer{□Dry amorphous □ Oil amorphous} □ Special transformer{Rectifier, Furnace, Mine, Etc} |
|
Transformer basic data selection
|
Country of use: |
|
|
Phase number: |
□Three-phase(S conventional) □ Monophase □Other( ) |
|
Frequency: |
□50Hz(conventional) □60Hz □ Other( ) |
|
Transformer oil: |
□#25(conventional) □#45(minimum temperature below-25℃) |
|
Rated capacity: |
□( )kVA Conditions of use □Outdoor type □Indoor type |
|
Altitude: |
□Less than 1000m(conventional) □1000-2000m □3000m以上 over |
|
Rated voltage(High voltage) |
□6kV □10kV □20kV □35kV □66kV □110kV □220kV □Other( ) |
|
Rated voltage(Low pressure) |
□0.4kV □0.66kV □10kV □10.5kV □35kV □其他 Other( ) |
|
Connected group |
□Dyn11(conventional) □Yyn0 □YNd11 □li0(Single-phase) □Other( ) |
|
Impedance(%): |
□4% □4.5% □5.5% □6% □6.5% □7.5% □8% □Other( ) |
|
Voltage regulation mode |
□Voltage regulation without excitation(conventional) □On-load voltage regulation(Z) |
|
Voltage regulation range |
□±2*2.5% □±5% □±3*2.5% □Other( ) |
Transformer accessory selection
|
□Fan □Temperature control{□ Common □With 485 computer interface} □Dry case{□ Ordinary steel sheet □Aluminum alloy » Stainless steel} □Protection level of dry case(□IP20(Conventional) □IP( )} □Dry case height requirements{□None □Requirements[ ]} □ Cable out mode of the dry variable shell {□ Up-and-out □ Up-and-down □Down-in/DOWN-out □Down-in/UP-out □Down-in/DOWN-out □Down-in/ side-out [□Left □ Right-out]} |
|
Note: 1. (Dry change requirements s 100kVA transformer does not include fans, such as fans, need to be charged 2. (Oil changes <630kVA transformer does not include temperature control, gas relay, if necessary, need to increase the fee) |
Other special requirements(additional charges apply below)
|
Dry transformer |
□Shell and bottom plate{□Ordinary □Fully sealed} □Travel switch □Magnetic lo □Zero sequence transformer □Copper bar to the low voltage cabinet □Protective mesh □Lighting □100kVA or less Fan □Shock absorber |
|
Oil-immersed transformer |
□No.45 oil for non-low temperature areas □Designated brand on-load voltage regulator □400kVA and below low voltage outlet OABC phase with wiring terminals □630kVA or below requires temperature control □800kVA or below Low voltage outlet phase 0 requires wiring terminals □630kVA and below must be equipped with gas relay |
GNEE TRANSFORMER Industrial Layout
Asia:China, Philippines, Cambodia, Malaysia, Myanmar, Indonesia, Vietnam, Mongolia, Japan, Taiwan Province, Bangladesh, Sri Lanka, Lebanon, Saudi Arabia, Turkey, Armenia, Iraq, Iran, Kazakhstan, Kyrgyzstan, Tajikistan, Uzbekistan
Africa:Egypt, Ethiopia, Angola, Botswana, Burundi, Cape Verde, Congo, Guinea, Ghana, Gabon, Zimbabwe, Cameroon, Kenya, Rwanda, Malawi, Mauritius, Mauritania, Mozambique, South Africa, Nigeria, Somalia, Chad, Central Africa
North America: Aruba, Panama, Dominican Republic, Costa Rica, Honduras, Caribbean region,Canada, United States, Mexico, El Salvador, Guatemala, Jamaica
Europe: Bulgaria, North Macedonia, Finland, Norway, Ukraine, Greece, Hungary, Italy, United Kingdom
South America: Argentina, Paraguay, Ecuador, Colombia, Guyana, Venezuela, Uruguay, Chile
Middle East: The Middle East region
Oceania: Australia, Papua New Guinea. Fiji